Run Pi in tmux

Pi works inside tmux, but tmux can report Shift+Enter, Ctrl+Enter, and plain Enter as the same key. Enable extended keys so Pi can distinguish them.

tmux -V

For tmux 3.5 or newer, use the recommended CSI-u configuration below. For tmux 3.2 through 3.4, use the older-version configuration.

Add these lines to ~/.tmux.conf:

set -g extended-keys on
set -g extended-keys-format csi-u

Pi requests extended-key reporting when the terminal does not provide the Kitty keyboard protocol directly. CSI-u is the most reliable format for forwarding modified keys through tmux.

The configuration applies to the tmux server. To guarantee that it is active, close your tmux sessions and start a new server.

If you choose to stop the server from the command line, save your work first. This command terminates every session managed by that server:

tmux kill-server
tmux

Start Pi inside the new tmux session and check that:

1. Shift+Enter inserts a new line in the editor.
2. Enter submits the prompt.
3. Alt+Enter queues a follow-up on macOS and Linux. Windows and WSL use Ctrl+Q by default.

If these keys still behave like plain Enter, verify that the terminal outside tmux can report modified keys. See Configure your terminal.

These versions support extended keys but not extended-keys-format csi-u. Add only:

set -g extended-keys on

Pi supports the xterm modifyOtherKeys format used by these versions. Restart tmux and repeat the verification steps.

For older versions, upgrade tmux or use Pi outside tmux rather than relying on modified Enter shortcuts.